Page History

...

Lab specification and setup Lab Specification and Setup
1. Evaluate lab requirements from RA-2 (if possible ... may need to read between the lines but this will at least help to give feedback to RA-2 or RI-2)
2. Compare with current OPNFV lab spec. (aka Pharos spec.) and highlight any gaps / issues.
3. Develop / document draft of a CNTT RI-2 lab spec that can be used to deploy and test all Cloud Infrastructure capabilities specified in RA-2. This will be an input to RC for requirements of a CNTT "approved lab" as part of LFN OVP 2.0 (conformance program)
  1. What would be a reasonable number of compute nodes + spec and network topology?
  2. What are differences to CNCF test-bed?
Install and configuration of BMRA Kubernetes Bare-Metal Install and Configuration
1. Document configurations / learning (configuration of hardware / firmware / software)
2. Cookbook to follow install with configuration steps
3. Document issues run into since its a different environment (compare to the CNCF test-bed)
Map BMRA features against RA-2 requirements Kubernetes Bare-metal Features
1. Features of BMRA that map to RA-2 requirements
2. Features of BMRA that point to requirements missing from RA-2
3. RA-2 requirements not met by BMRA
Testing RI-2 (Kubernetes bare-metal testing ) Kubernetes Bare-metal Testing
1. WIP

...

Specify baseline for installer starting to provision (predeploy validation check?)
Features (e.g. SR-IOV) and what needs to be provisioned to enable
What is done by the installer and what is outside (e.g. BIOS and bootloader config.)
...

CNCF Test activities related to RA-2 / RI-2

...